FEATURE:-

Wide range of sizes to suit your requirement 10, 25, 50, 75, 100, 125, 200 and many more

Calibrated needle valve to adjust purge flow to actual outlet flow and pressure conditions

Overlapping cycle time time to provide constant downstream pressure and dew point

Normally open shuttle valves allow air flow through dryer if power failure should occur

Integral wall mounting racket on all models

Easily  installed - just make the air connections and plug in the electrical power cord

Versatile piping options-two inlets and outlets infront, one inlet and outlet in rear

Lightweight  and compact

Trouble free and reliable perfomance. 

TECHNICAL DATA:

1) To extend the service life of the desiccant power

    install a siemag 5-micron general  purpose filter and a micro

    coalescer upstream of dryer

2) To remove possible traces of desiccant power

    install  a siemag 5-micron general purpose

    filter downstream of dryer

MATERIAL OF CONSTRUCTION:

Panel   -   M.S Duly powder coated

Tower & Body   -   Aluminium

Elastomers   -   Nitrite & Polyurethan

Desiccant   -   Activated Alumina

RATED OPERATING CONDITIONS:-

Maximum inlet Pressure    -   150 psig (10.3 bar)

Minimum inlet Pressure    -   21 psig (1.4 bar)

Temperature range   -   35° to 122° F (20° to 50° C)

SPECIFICATIONS:-

Fluid     -     Compressed air

Ports     -     1/2" BSP

Outlet Pressure Dew  Point    -    -40°F (-40°C)

Voltage     -     240/220v 50-Hz ,1 Phase